1-YEAR

Warranty on genuine parts

Kenmore Appliance Repair in San Francisco

We repair Kenmore refrigerators, washers, dryers, and dishwashers across San Francisco and the Bay Area, usually the same day. Your Kenmore was built by Whirlpool, LG or Electrolux, so parts are still available, and every model stays serviceable. Free diagnosis, genuine parts, one-year warranty.
Kenmore Appliance Logo

Kenmore appliances we repair

Kenmore covers the whole house, and we service the full lineup. Here is what breaks most often on each one.

Kenmore refrigerator and freezer repair

Not cooling at all, freezer cold while the fridge warms up, running nonstop, frost on the back wall, water under the crisper, or no ice. We service Whirlpool-built 106 models and LG-built 795 Elite models, including sealed system and compressor work.

Kenmore washer repair

Will not drain, will not spin, leaking, loud on spin, or walking across the floor. Whirlpool-built 110 washers show F codes and LG-built 796 washers show letter codes, so we read yours correctly the first time. Elite, Oasis, Duet, and HE all serviced.

Kenmore dryer repair

Runs but no heat, clothes still damp after two cycles, loud thumping, will not start or shuts off mid-cycle. Most no-heat calls trace back to a restricted vent rather than the dryer. Gas and electric both serviced, from igniters to elements and thermal fuses.

Kenmore dishwasher repair

Standing water in the bottom, dishes coming out dirty, will not start, leaking onto the floor or not drying. We service Whirlpool-built 665 and 110 platforms plus Frigidaire 587 and Bosch 630 units, from drain pumps to wash motors and door latches.

Kenmore range, cooktop and wall oven repair

Gas burner will not light, long delay before ignition, oven will not heat, temperature running 50 degrees off, broiler works but bake does not, or a dead touchpad. All gas work is handled by certified technicians, including igniters and valve assemblies.

Kenmore microwave, ice maker, wine cooler and disposal repair

Over-the-range microwaves that turn but will not heat usually need a door interlock switch or a magnetron. Ice makers come down to the module or the water inlet valve. Wine coolers and beverage centers come down to the compressor or thermostat.

Common Kenmore problems and what causes them

The symptom narrows the circuit and the model number narrows the part. Below are the five calls we take most often in San Francisco. Cleaning a pump filter or a condenser coil is safe to try yourself. Gas, refrigerant and control board work is not.

Kenmore refrigerator not cooling

If nothing cools, suspect the compressor or start relay. A freezer that stays cold while the fridge warms means the evaporator fan, a frosted coil or blocked vents. Constant running points to dirty condenser coils. Elite 795 models are LG units with a known compressor fault.

Kenmore washer not draining or spinning

Work the drain path in order, from the pump filter and coin trap to the drain hose and then the pump. A washer that will not fill points to the inlet valve; one that will not spin to the door lock or motor control board. Grinding means tub bearings; walking means worn rods.

Kenmore dryer not heating

On electric dryers, the thermal fuse, heating element or high-limit thermostat fails. On gas it is the igniter or valve coils. Nearly every one is caused by a restricted vent, and San Francisco flats run long shared ducts, so we check the vent on every call.

Kenmore dishwasher leaving water in the bottom

Standing water usually means the drain pump, a clogged air gap or a disposal knockout plug left in after an install. Dirty dishes point to the wash pump, chopper or a blocked spray arm. A dead panel is the door latch, and leaks are the gasket or tub seal.

Kenmore oven or cooktop not heating properly

On gas ovens, the igniter is the number one failure, showing as slow ignition or no bake heat while the broiler still works. On electric, the bake element or a drifting oven temperature sensor is the usual cause instead.

Kenmore error codes and what they mean

A Kenmore shows the codes of the company that built it, not Kenmore codes. On Whirlpool-built 110 washers, F20 means no water entering and F21 means a long drain. LG-built 796 washers use letters instead, where OE is a drain fault, UE an unbalanced load and LE a locked motor. On refrigerators, Er FF is the evaporator fan, Er dH the defrost heater and Er CF the condenser fan. Dryers show F28 for a moisture sensor fault.

Find your appliance below for the full code list and what each one costs to put right.

Kenmore refrigerator error codes

→

Kenmore dishwasher error codes

→

Kenmore washer error codes

→

Genuine Parts, Certified Technicians and 35 Years in the Bay Area

We have serviced Bay Area appliances for more than 35 years. Our technicians are certified, background-checked, and carry stocked vans, and we are a factory-authorized service partner for brands including Miele and Whirlpool.

That manufacturer relationship matters more on Kenmore than on any other brand. Kenmore never built a single appliance. The first three digits of your model number name the company that did, so a 110 or 665 takes genuine Whirlpool parts, a 795 or 796 takes genuine LG parts, and a 253, 790 or 587 takes genuine Frigidaire parts. We decode the prefix before we order anything, which is why the right part arrives the first time.

Every visit includes a free diagnosis, a written estimate before any work starts, genuine OEM parts and a full one-year warranty on parts and labor. Same-day service is available across San Francisco and the Bay Area.

✓

Kenmore’s model prefix identifies the original manufacturer

✓

Parts matched to the full model number before ordering

✓

Whirlpool, LG and Frigidaire builds get the appropriate OEM components

✓

Certified, background-checked technicians arrive with stocked vans

✓

Free diagnosis and a written estimate before repairs begin

✓

Completed repairs carry a one-year parts and labor warranty

Kenmore repair cost in San Francisco

Most Kenmore repairs in San Francisco cost between $150 and $400 for parts and labor. Major component work such as a compressor or sealed system repair runs $500 to $900. Your diagnosis is free and you get a written estimate before any work starts, so you pay only for the repair you approve.

MOST REPAIRS

$150–$400

Heating elements

Thermal fuses

Drain pumps

Wash motors

Oven igniters

Our Repair Process

From your first call to the final check, every repair follows the same five steps, so you always know exactly what happens next.

01

Schedule Service

We only accept calls. Talk directly with our team, describe what your dishwasher is doing, and we’ll schedule a visit that works for you, usually the same day.

02

Expert Diagnosis

A factory-certified technician arrives, tests the full water path, electrical path, and mechanical components, and pinpoints the exact cause of the failure. The diagnosis is free.

03

Upfront Quote

Before any work begins, you get clear, transparent pricing: one flat rate for the repair, agreed by you in writing. No hourly billing, no hidden fees, no surprises.

04

Same-Day Repair

We complete most repairs during the first visit using genuine OEM parts carried in our service vehicles. If a special part is needed, we order it and return fast.

05

Warranty Protection

We complete most repairs during the first visit using genuine OEM parts carried in our service vehicles. If a special part is needed, we order it and return fast.

Neighborhoods and Areas We Cover

Frequently Asked Questions

Read the model number on the tag. It looks like 110.12345678, and the three digits before the dot name the builder. 106, 110 and 665 are Whirlpool. 795 and 796 are LG. 253, 790 and 587 are Frigidaire. Send us that number when you book.
Most repairs run 150 to 400 dollars, including parts and labor. Major component work such as a compressor or a sealed system runs $500 to $900. Our diagnosis is free, and you get a written estimate before any work starts.
That pattern almost always points to the evaporator fan, a frosted evaporator coil or a defrost circuit fault rather than the compressor. Cold air is being made but not moved into the fresh food section. It is usually a same day repair.
F21 is a long drain code on Whirlpool-built 110 washers, meaning the machine could not empty in time. Start with the pump filter and coin trap, then the drain hose. If the code returns after clearing the path, the drain pump needs replacing.
Yes, all of them. Elite refrigerators are usually LG-built 795 units, Oasis and HE are top-load Whirlpool platforms, and Duet is the Whirlpool front-load platform. We carry parts and diagnostic experience across all four.
Same-day service is available across San Francisco and the Bay Area for most calls booked before midday, subject to the part being on the van. If a part has to be ordered, we will tell you the exact return date during the free diagnosis.

Services Schedule Form

This field is for validation purposes and should be left unchanged.

5758 Geary Blvd #128,
San Francisco, CA 94121, United States